3D Printed duel pump holder

Following on from testing two air pumps for the 'Bad Motivator' smoke system. I drew up in AutoCAD Inventor (works program) and 3D printed off a duel pump holder.

Click on this image to link to actual 3D.stl file via Thingsiverse

It printed out quiet well and is actually a more tighter fit then the single version I had previously made. I think because of the extra supports, they give less flexibility.

And here's a picture of them fitted.

This is still all under development and a bit of fun, so will see if I actually install this set up.
I'll post this up on my Thingiverse account, but check out the single pump via the link.