I've used araldite glue to secure |
Also looked at fitting a low power red LED under the mesh.......if there's space to fit it!
Above pic shows just the LED.............
.....................Pic below shows with a diffuser and wire mesh [temp positioned] in place. The mesh will be pressed further down inside.
There is just enough space inside the Motivator, once the washer and nut are fitted. Just need to wire up the battery properly and fit a switch...... not another switch! lol
Next piece is to fit the second component onto the Motivator. The 'flat' area seen in the first pic above is where it will be fitted.
No comments:
Post a Comment