October 20, 2022

Life-form scanner - R4-D4 - part 20

June 2022
Back in June, whilst I had R5’s bad motivator setup out of R5’s dome, I thought I’d refresh my memory of where I was with R4’s Life-form scanner.

After recently salvaging parts from a broken 3D printer, the parts gave me a better idea of how to operate the lift system.
So this version will be belt driven.

I needed to design some new parts so that the original setup could still be used.
A new lower bearing holder was drawn up and 3D printed. This clips over the lower bracket and has a locking screw to secure.

The main lift unit had a bracket added to clamp the belt onto.

The upper unit had to have a new servo holder designed up as it needed to be turned 90°’s. This has a location tab and a securing screw.

July 25th
Test printing done and then some more redesigning. The bracket needed some work done after all, so it had the lower bearing included in its update. This bearing holder also needed to protrude more to allow clearance. This also means it replaces the ‘clip over’ version.

Next up was the main lift bracket.
This was also modified to protrude more, for the belt to be aligned and to allow clearance and full travel up to the top.

October:
With the progress made with the Bad Motivator setup, these will be included on here.

No comments:

Post a Comment