Used the first plate as a guide, I
marked onto a new piece of scrap aluminium,
the same mounting hole positions
and drilled through.
These are the two holes furthest apart [top & bottom in pictures]
I then marked the new position for the motivator securing bolt to go through [middle hole],
which is
off-centre now to the securing bolt holes, and drilled.
This will allow the Motivator's position to fit better in the Pie Hole opening.
 |
| Motivator Base Plate, 1st attempt on left, UPGRADE version on right. (which still needs a hole for wires to fit through) |
No comments:
Post a Comment