February 20, 2020

Relay switch holders - 3D printed

Relay switch holder

I designed this holder for the relay switch from 'Model Radio Workshop' (link)
It's just a simple holder to help keep it in place, once inside R5-D4.
I've also drawn up a dual holder, see other link below.

As per usual, I drew it up in AutoCAD Inventor, works program, and then printed it out on the Ultimaker S5.

Thingiverse Link




This dual version, is not just a simple, placing two of the above together, I had to modify the design slightly.



Thingiverse Link for dual holder

This was the third cable clip design I came up with. The cable easily folds around and slides under the clip, holding the relay unit in place.

No comments:

Post a Comment