These were a snug fit, so tested them out of the cylinder. I then removed the dowel/semi-circle fittings and re-fitted them into the cylinders, and test fitted it back on the centre leg.
 |
| same side as above, different angle |
October 05, 2011
Ankle Cylinders fitted to Centre Leg
Marked the positions on the centre leg for where I would need to drill holes for the fixing dowels in the cylinders to fit into. Due to a screw on one side, the holes weren't going to be symmetrical, but that doesn't matter.
These were a snug fit, so tested them out of the cylinder. I then removed the dowel/semi-circle fittings and re-fitted them into the cylinders, and test fitted it back on the centre leg.
These are not glued in yet, as still have to make up the wedge's and also spray centre leg white.
These were a snug fit, so tested them out of the cylinder. I then removed the dowel/semi-circle fittings and re-fitted them into the cylinders, and test fitted it back on the centre leg.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment