February 20, 2014

Body Skin 5.1 - Side Vent work No.2 & Rear Pocket Vent

Started cutting out the side vent slats yesterday and finished after work today. using a Stanley knife to score then a hacksaw blade to cut carefully along the lines.
R5D4 side vent
Next was watered down PVA glue to the cut edges to seal. Grill supports are cut up scrap pieces of wood, these will be for fixing the side grills inside the body.

Rear Pocket Vent
I glued the pocket part of the Rear Vent into place.
Pocket VentPocket Vent

Applied wood filler....
R5-D4 Pocket Vent
......................once dried, sanding is required.

No comments:

Post a Comment