Sprayed pocket parts white , then glued top part and bottom/sides together.
Marked up side vent slots.
Masked off the shoulder hole, to be filled in with P40 and then sanded smooth.
Sanded the filler around the rear Coin Return.
And then painted over it with silver to blend in.
Grooved and recessed one panel [pic below].
Then a lot of sanding and PVA glue to smooth and seal the cut wood.
Next, to apply some wood filler.
Positioned restraining bolt on body. There is a washer on the hex side of the bolt, but made up a restraining plate bracket and fitted it behind the skin, just to make sure it stays there lol.
And then painted over it with silver to blend in.
Grooved and recessed one panel [pic below].
Then a lot of sanding and PVA glue to smooth and seal the cut wood.
Next, to apply some wood filler.
Positioned restraining bolt on body. There is a washer on the hex side of the bolt, but made up a restraining plate bracket and fitted it behind the skin, just to make sure it stays there lol.
No comments:
Post a Comment