I've decided on NOT fitting the perforated metal behind the L.D..P opening.
Tapped in some panel pins, parallel to each other. Then drilled larger clearance holes in the front of the top ring. These will help to tie in the top piece of the L.D.P., for when the P40 resin is applied along the inside edge.
 |
| The pencil lines are where the panel pins are, you can just make them out. |
Applied wood filler also to the leading edge angle, last night. Then lunchtime today I used the works sander to sand the angle flat and smooth.
I primer sprayed up the lower piece. Then marked up and cut out two side pieces.
No comments:
Post a Comment