So after the event at The Galleries, Bristol. There were a few things I wanted to sort out with G4.
These I’ll be covering on this Blog and the Mouse Droid forum, as GOUD-4’s Blog doesn’t seem to attract much interest/traffic. I’ll be transferring all of the build details over onto this Blog as a new ‘page’.
- Sound system set up.
- Panel activation….
- 3D new parts.
3D printing:
I needed a new bracket/holder for the new ESC (electronic speed controller). So I measured it up and drew up a suitable holder, which also incorporated the on/off switch.
Also drawn up a speaker bracket, just need to print it.
Sparkfun sound card bracket:
I drew up this bracket to hold the SD card reader sound card.
I already had a bracket holder for the voltage regulator.
Transmitter/receiver:
I eventually found out what was causing the remote signal issue.
See Transmitters - Volantex Exmitter's post for details.
Sound system:
I had started this a while back, but was pressed for time to complete. Now it’s time to finish what I started. Been waiting on a relay switch that can be activated via the transmitter, similar to how R5’s sound system is triggered. I’ve soldered up the connectors, I next need to fit all the components onto a board and find a spot to install it.
Top Panel opening:
I also have the top opening panel to sort out. The bracket is printed and the servo is fitted into it. Its then just a case of connecting it up to the receiver.
No comments:
Post a Comment