07/03/2013

Battery Box No.1 - 1.6 - Battery Straps

Cut & glued on 3 angles & front strip in-fill. Then cut out front raised 'blue' pieces 4 off, filed angles.Applied watered down PVA glue to seal. This piece will be glued on once painted [this is the flat piece that's just resting on the battery strap in the picture below]. Cut & glued in place 2nd lower piece. Then started on top pivot pieces, 1 done.
A bit of Sanding & applying of wood filler.

This picture shows one 'mock-up' of battery harness strap :)

No comments:

Post a Comment