Started on drilling holes in the back's of the coin slots to accept 4BA screws (smallest suitable thread I could find). These will go through the perforated metal angle [with clearance holes in] and then be screwed to the inside frame upright.
Positions marked onto the angle.
Coin Slots all drilled and thread tapped.
Just need to cut down in length, the four on the left of picture
This is them starting to be assembled
A few of the clearance bolt holes were off centre, so had to file them up for the screws to fit.
I like the fact you can see the perforated metal through the slots :)
Just need to cut down in length, the four on the left of picture
This is them starting to be assembled
A few of the clearance bolt holes were off centre, so had to file them up for the screws to fit.
I like the fact you can see the perforated metal through the slots :)
No comments:
Post a Comment