05/04/2011

Base Plate

Saturday I cut out slots for the Power coupler and Octagon Ports. This is because the depth was the same as the base and wasn't possible to recess them, will worry about this later. Did manage to recess where the coin returns  & lower vents will fit. Cut to size the lower plate that will support the lazy suzan and rotary piece for the dome.

I had drilled out 6 holes for the leg bolts, but with the lower plate in place, I'll only be able to use 5 off. Not the end of the world.

Also had time to mark out the top plate O/D and I/D.

No comments:

Post a Comment