‘Trading Card Dispenser’ control box - servo switch controlled

October 1st

Back at the beginning of the month, before I fitted the remote control, inside my transmitter, I had thought about utilising the servo activated switch module, that I’d bought for the GOUD-4 droid.

So I combined the bracket I’d designed up for it with a new saved version of the control box base.

Some other modifications were needed to accommodate the alternative model timer circuit board I’d bought, as well as doing away with the lid's side clips and replacing them with a brass knurled threaded insert. The lid section needed alterations to and the design of the slots was simplified. I did away with the LED ‘on’ indicator as it wasn’t necessary.

Have been test printing both in work and at home. It was good to use my printer that’s not been used in over a year. Dusted off the Tevo Tarantula Pro (Orange), fired it up, first print, perfectly just like always.

Probably should mention using online program, Astroprints for creating the gcode for printing on the Tevo.