Leg Assembly 1.5 & Ankle Bracelet 1.1

Applied more wood filler to the leg, mainly to the wood 'grain' surface. Once dried, this will require more sanding of the leg.

Marked outline onto 3mm hardboard, then cut out what will be an 'ankle bracelet' for the leg.

If this was a metal build, this piece would be made in one piece and fitted between the upper leg and lower ankle section. But as my leg is made in one piece, the bracelet has to be in two pieces to fit.

This is the back face view. Wood filler will be used to fill the gaps on the end of the rear strip.

I used more wood filler to build up the top of the ankle, as can be seen in the previous picture, where the 'ankle bracelet' will sit. As the board has a textured underside, I applied a thin layer of filler, to be sanded smooth.

Am thinking screws to fix in place at the moment, which will be hidden by the booster cover. Not sure how to fix the rear strip ??



Here I test fitted some electrical cable through the leg. I had to feed it up from the ankle to the shoulder hole. This will be connected to the feet motors and batteries.