September 2023
Mike wanted to reinstall his Teeces LED’s in his R2 dome again. This was after his last set of logic’s from DP, got ripped out when wires dropped and got caught in the dome gear.
So I uninstalled the DP set and made a start on cleaning things up. I made up some cardboard templates for the holes, marked the position and drilled into the resin DJ Design components using a manual hand drill and a 3.5mm drill bit. I cut down some 20mm long M3 threads and screwed on a nut to depth required. I then fitted them through the cardboard template into the pre filled holes with Araldite epoxy glue. I then fitted the screens to help with alignment.
The three Holoprojectors required new location holders, so they were sent to the printer.
I also needed to print two new PSI board holders, after a slight design modification for a better fit.
Whilst these were printing, i made a start on connecting up the cables and wiring the switches back in.
Just waiting on them being delivered.
Another happy customer 🙂👍🏽
No comments:
Post a Comment