3D printing: SD card Sound board holder

 So i needed brackets/holders for the components for GOUD-4’s sound system.

Some i found on Thingiverse:

• The amp bracket
• The voltage regulator bracket

….the others I had already drawn up, like the mini voltage regulator. Next up tho was a bracket for the SD Sound board card reader. This is the now discontinued Sparkfun model that’s continued unbranded, to be produced and sold on eBay.

It took about four attempts and designing the bracket to both enclose, support and be a good secure fit for the board. I made a cut out in the rear to help with pin identification. There’s a lip on one end that the board clips under to ensure it doesn’t come out.