3D Printed Badge Display's

 I wanted a display stand for my 26mm O/D pin badges. This one was my first test print but second design idea.

This stand has printed holes for the backing pins to fit through. The pins weren’t all in the same position though. So for the file release version, I’ll remove these holes. Simply press the pin into a piece of paper and then position it in the recess, then drill your hole, large enough so that the second spike part also fits through. I had to use a small piece of rubber sheet on the rear as one of the pins clasp wasn’t tight enough, but the others wouldn’t of fitted if the print was thicker.

Next up was to convert the design for two & one pin badge versions.

Link to my Thingiverse page,

.................where these will be going up on soon.