Teeces LED work for Mike's dome 2 [August 2021] part 2

Tasked with installing another set of LOGIC’s in an R2 dome.

After shopping around, I decided it would be easier to make the cables myself.

Used a PSI design off Thingiverse and modified it slightly. The rings I didn’t need, but I did require a retaining ring, can be seen below in picture, too right. I also drew up a honeycomb screen.

I drilled out location holes for the retaining threaded, cut down bolts, and mixed up two part epoxy to secure them in place.

Latest work:

I wired up these illuminated switches for the Teeces and the PSI’s.

Next is the Holoprojector LED’s and holders for them (3off). Then it’s connecting everything up and passing the dome over to Paul.F to program the Arduino.