Before spaying up the screen white & then getting to work on weathering it.....see below.
The piece of wood that sits between the two utility arms, needed to be thinned down for the screen to fit. My original measurement was for a snug fit, but the print was just a bit higher than expected, so rather than take a blade to the 3D screen print (loosing details) I decided to trim the wood piece. This then needed some wood filler before repainting. It was black and I did respray it matt black again, but am thinking white so it all blends together.....
Once all dryer I’ll start weathering this piece and the screen before re-installing.
No comments:
Post a Comment