R0-D4 Dome update 2020 (Part 2)

Sprayed up the neck ring with plastic-kote  white paint & left it to dry for a day or so. No pics of this but onto the next colour, Red.

Thankfully I still have the original wood neck ring, so that I could match up the painted stripes.

There are four quarters which have thicker vertical bands. These had a stripe of masking tape and the pin strips to prevent paint bleed.

Next came the top and bottom bands, again using the pin stripe tape width, with an additional single thickness vertical line at each centre of the quarters. As can be seen in above picture.

Then the fun bit, spraying with the red metallic’ish paint.

Looking good. I left this for about 20mins before starting the messy bit, removing the pin stripe tape.

I had made sure to corner crease the edges of the over lapping tape, but this isn’t the best way, cutting the tape is. But I didn’t want to damage the paint and it’s not critical. Weathering will cover up and also chipped paint too.

Once all the tape was off, one final picture before being left to fully dry.