Finished painting up the two half sections.
Liked how the spray came out on this, couldn't of achieved this finish if I'd tried lol. The can was probably cold, it was cold in the garage. Once dry, I scrapped off the indent panel, masked it off and applied blue paint as on the first test piece. I did some light scrapping off of the silver to reveal the matt black underneath, weathering look.
~~~
The changes I had made to the front lens holder, worked a little to well, so that the lens would only partially click into place. Back to the design and changed back a few dimensions and am awaiting a test of a small section to see if these are correct. Then I can hopefully print the final lens holder.
No comments:
Post a Comment