After test fitting the location to install the support bracket, I found that I needed to locate the box closer to the outside diameter of the body. This was because the distance the card is ejected, is almost the same distance that the bracket and dispenser is located inside the body.
So I needed the dispenser to be this much further forward.
Without having to cut a slot in the body somewhere, I found a position behind the Utility arm. This required a redesign of the bracket locating points and also move the position it holds the card dispenser, further forward.
This is the new bracket (upside down view) as the supports were created using the conical enabled selection.
This bracket also needs a front, so that was the next item to draw up, more in next post.
No comments:
Post a Comment