My own Magnetic Power Connector 1.1

Back in October 2019:

I finished off designing the connector blocks.....

The connectors are split into two sections, blue/red & green. This is so that the contacts can be soldered without damaging them. Then the magnets are fitted and the two half's (e.g. green/blue) snap together.
There's still some fine tuning to do but happy with the results. The holes do need to be cleaned out with correct size drill bits, but not by much.

Here's some of the previous design attempts and prints.

I've not had the chance to print out the final design and test, hopefully next week.

Roll on to 2021…..

Can’t remember what happened, but this new idea came up in my mind again, so had a few new ideas which didn’t use electrified magnets lol as they’re prices have gone up 🙄

Next idea was a modified & a bit more simplified as well as scaled down in size.

One magnet this time.

……..another project I need to return to at some point lol.