So yesterday I re-designed the servo panel and sent it to the printer. Four hours plus later, it finished....just in time for me to leave work.
Once home, I removed the raft & supports. There wasn't much cleaning up needed. Later I then test fitted the components & whilst I had some free time, connected up what I could.
It may look complicated, but I don't do complicated lol, all 'plug-n-play' here.....with a bit of splicing of the digital volt meter to be soldered to the output pin connectors of the voltage regulator unit. The bottom two red wires are to the momentary switch I used for testing. This you can see in the picture below.
No comments:
Post a Comment