Extra Projects & Event Page's

June 23, 2017

R0-D4 dome upgrade 2017 - 1.1

Measured and cut out the ring yesterday. Then marked up where the bearing location studs will go, in relation to the domes skeleton frame work.
And here it & R0's dome, next to R5's dome, for ref work on how I did it etc. Next up was to mark out the recessed parts for the studs.
And then I drilled and countersunk the holes used to fix the new ring to the skeleton frame.

~~~~~~~~~

Next up was to make the stud location blocks. These are thicker than the base ring and help locate the dome securely onto the bearing. I marked the skeleton frame position onto the base ring and then cut out some blocks from 18mm thick plywood. Once I had the position of the stud marked, I drilled out a slightly larger hole so there is clearance allowing for misalignment with the studs. I then placed the ring on the bearing, and using the studs as a guide, I glued the blocks into place.
I did these one at a time. Once the glue was dried, I then drilled and screwed the blocks in place.

Here's the view from inside the dome.
Once these are all in, I then need to look at the new metal neck skin.....

No comments:

Post a Comment