Tuesday 20th April Missed
measured the outer skin width, so needed to trim it down by 3mm. As I don't
have a dremel cutting wheel, it was out with the metal cutting saw blade (used
for cutting metal, but the teeth are small enough not to tear the wood).
Bout 25mins later, I'd finished. Next, was positioning the neck strip so the join would be at the back. I measured up from the bottom edge 10mm and then evenly spaced out the panel pins. I put a few more into the end of the strips where they joined.
As you can see from the last picture, the strip end still doesn't want to curve to the frame just yet.
No comments:
Post a Comment