Electrical Board......to mount the electronics onto......eventually = 1.0

A board or 'electronics board' is needed to mount R5's electrical components onto. I found a piece of 5mm thick plywood, but then found some clear acrylic in work. So using this instead, I measured across R5's two internal vertical panels and cut it to a suitable size.

I had already cut up some 'U' section aluminium and then cut off one of the sides to

form 'L' shaped brackets. These will be screwed to the frame and then the clear panel will

be bolted ont the 'L' brackets.

It's that small thing just below the bolts, lol

I've also bought some servo leads, to link up the reciever to the speed controller, when I get it. And in the meantime, I also bought a servo to use as a test unit &
a power pack to run temporaly run the Radio Reciever unit
[it will eventually be powered by the Duel Foot Motor Controller]

It's only on two of the angle brackets as I'm still thinking about position of the panel once batteries are installed below it. Also it can pivot at the moment, which might come in handy.

I kind of know what will go on the board, standard items are speed controllers (feet and dome), junction block, radio reciever and maybe a sound card......small steps people.....small steps lol.