Drilled clearance holes in the back pieces of the horseshoe. This will allow the bolt heads to be recessed inside, to clamp the hydraulic in place.
I cut these bolts tooooo short, so will be using others lol.
Have also done two of the four buttons. [drilled & thread tapped them]
The top 'button' is slightly angled upwards. So i cut a small piece of hardboard & glued it in at the bottom of where the hole would be. I'll then fill in to form the angle. I also marked where the holes are to be drilled for the buttons.
 |
| Small piece of wood placed to start my angled face |
Applied wood filler around the inside of the recess, sanded and repeated......
Also applied wood filler around the outside to start to build up areas.
No comments:
Post a Comment